AIP830 YOKOGAWA  扬声器(声音功能)

AIP830台式HIS单回路操作键盘的硬件规格。

它包含一个独立的uSB扬声器(声音功能)，而不是嗡嗡声报警(蜂鸣器声音)AIP830键盘可用于一台桌面型HIS。

硬件规格

各系统通用的安装规范和环境条件请参见《系统概述》(Gs 33KO1A10-50E、Gs 33KO1A20-50E)。

-类型:平面键盘(声音功能:UsB扬声器)- pc接口:

接口连接器:USB A型× 2(*1)符合USB标准

操作键盘功能:USB 2.0(全速，总线供电)

USB 1.1(全速，总线供电)

—输入电压:5v ~ 5% (PC机USB接口供电)

—最大消耗电流:1a

-重量:2.0kg(不带VESA支架)，2.5 kg(带VESA支架)(*2)-底盘颜色:黑色(相当于Munsell No.N1.5)

—AIP830属于lEC61010-1安装类别l类

(不与主电源直接连接的设备)。

操作环境

环境温度:

5 ~ 40℃(正常运行)

-20 ~ 60℃(储运中)环境湿度:

20 ~ 80% RH(非冷凝)

*1:两个连接器必须始终直接连接到PC。

*:带VESA支架的AIP830必须安装在至少能承受10kg重量的地方。

法规遵从性

以下标准的详细信息请参见“系统概述”(GS 33KO1A10-50E,GS 33KO1A20-50E)。

安全标准(cSA) (* 1)

冰标志)(* 2)

EMC合格标准[CE标志](2)(*5)

ic-Tick标记](3)[KC标记](4)

*: -当与AIP830连接的PC上有CSA标志时，AIP830才符合CSA标准。

:当与AlP830连接的PC上有CE标志时，AIP830才符合CE标志。*3:只有与alp830连接的PC上显示为c标记时，AIP830才符合c标记。4只有与AIP830连接的PC上显示为KC标记时，AIP830才符合KC标记。*5: CE标志中的EN 61000-3-2和EN 61000-3-3不在AlP830的适用范围内。

描述

模型:AIP830

单循环操作键盘:- 0

模式选择开关:-1

带模式选择开关

后缀代码:0

AIP830 YOKOGAWA  扬声器(声音功能)

the hardware specifications of AIP830 Operation Keayboard for Single-loop Operation forDesktop Type HIS.

lt contains an independent uSB speaker (a sound function) other than buzzing alarms (buzzer sounds)An AIP830 keyboard can be used per one Desktop Type HIS.

HARDWARE SPECIFICATIONS

For installation specifications and environmental conditions, which are common to the systems, refer to "SystemOverview" (Gs 33KO1A10-50E,Gs 33KO1A20-50E).

- Type: Flat keyboard (Sound Function: UsB Speaker)-PC Interface:

lnterface Connector: USB A type x 2 (*1)Conformable USB standard

Operation Keyboard Function :USB 2.0(Full-speed, Bus-powered)Sound Function :

USB 1.1(Full-speed, Bus-powered)

- Input Voltage: 5 V士5 % (Supplied from USB Port of PC)

- Maximum Consumption Current: 1 A

- Weight: 2.0kg (Without VESA Bracket)，2.5 kg (With VESA Braceket)(*2)- Chassis Color: Black (Equivalent to Munsell No.N1.5)

- AIP830 belongs to lEC61010-1 installation category Class l

(A device not directly connected with the main power supply).

-Operating Environment

Ambient temperature:

5 to 40C (for normal operaiton)

-20 to 6o °C (in storage and transportation)Ambient humidity:

20 to 80 %RH(Non-condensing)

*1:Both connectors must always be connected directly to a PC.

*:AIP830 with VESA Bracket must be mounted where it holds at least 10 kg of weight.

REGULATORY COMPLIANCE

For the detailed information of the following standards, refer to "System Overview"(GS 33KO1A10-50E,GS 33KO1A20-50E).

Safety Standards[cSA](*1)

iCE Marking](*2)

EMC Conformity Standards[CE Marking] (2)(*5)

ic-Tick Marking] (3)[KC Marking](4)

*:— AIP830 complies to CSA only when CSA mark is indicated on the PC which connects with AIP830.

: AIP830 complies to CEMarking only when CE mark is indicated on the PC which connects with AlP830.   *3:AlIP830 complies to C-tick marking ionly when it is indicated on the PC which connects with AlP830.4 AIP830 complies to KC Marking only when KC mark is indicated on the PC which connects with AIP830.   *5:EN 61000-3-2 and EN 61000-3-3 in CE Marking are out of scope for AlP830.

Description

Model:AIP830

Operation Keyboard for Single-loop Operation:-o

Without Mode selection switch:-1

With Mode selection switch

suffix Codes:0