DPM200   | 主站模块 | FC-SCNT01 |   NTMP01 |   NTMP01

型号：DPM200

PROFIBUS® DP主站模块

PROFIBUS@是一种得到广泛应用的现场总线，特别是机械工程和工

厂工程领域，即使目前有大量基于以太网的现场总线，其数量仍然持

续增加。门类广泛的外围组件和一个活跃的用户组织还将确保未来

PROFIBUS·的长期可用性。巴合曼电子为背板提供了一种现场总线模

块，既可用作主站模块，又可用作从站模块。SolutionCenter包含

个完整的配置器，其通过一致的标准应用，实现与其他制造商工程工具

的接口。

可将PROFIBUS® DP 接口模块(分布式外围设备)作为DP 主站、DP 从

站或作为多主站网络中为其它主站提供变量的组合主站/从站运行。过程

数据可作为逻辑输入/输出模块提供给应用程序，因此可以通过过程映像

或功能接口访问过程数据。

每个 M1 控制器最多支持3个 DPM200 模块

传输速率 9.6 Kbaud 至 12 Mbaud

·8 kByte 过程数据映像的寄存器

数据块的一致性锁是可配置的

线缆环通的两个内部桥接

现场总线和控制器之间的电气隔离

PROFIBUS@ DP 主站模块:8 kB x 16 DPM

过程映像大小 : 可通过 SolutionCenter 更新

固件 : 每个 M1 控制器3个

主站数量最大值  " 不使用中继器为 32 个，使用中继器为 125 个

从站数量最大值:Vo

PROHBUS@标准准 :每个从站模块 732 字节

DPM 中的数据长度  : 400 mA/5 VDC

环境条件

工作温度 :  30 至 +60°C

相对空气湿度(运行):  5 至 95%，无凝露

储存温度:   40至+85°C

相对空气湿度(储存) :  5 至 95%，有凝露

污染等级(按 IEC 60664-1 标准) :  2(无凝露)

Model: DPM200

PROFIBUS® DP master station module

PROFIBUS@ is a field bus that is widely used, especially in mechanical engineering and engineering

In the field of plant engineering, even though there are a large number of Ethernet-based fieldbuses, the number still holds

Continue to increase. A wide range of peripheral components and an active user organization will also ensure the future

Long-term availability of PROFIBUS. Bachman Electronics provides a fieldbus mode for the backplane

Block, which can be used as either a master or slave station module. SolutionCenter contains

A complete configurator, which implements engineering tools with other manufacturers through consistent standard application

The interface of.

PROFIBUS® DP interface modules (distributed peripherals) can be used as DP master and DP slave

Stations or as combined master/slave stations that provide variables to other masters in a multi-master network. course

The data can be provided to the application as a logical input/output module and therefore can be mapped through the process

Or a functional interface to access process data.

Each M1 controller supports up to three DPM200 modules

Transmission rate 9.6 Kbaud to 12 Mbaud

·8 kByte registers of the process data image

The consistency lock of the data block is configurable

Two internal Bridges of the cable loop

Electrical isolation between fieldbus and controller

PROFIBUS@DP master station module :8 kB x 16 DPM

Process image size: can be updated through SolutionCenter

Firmware: 3 for each M1 controller

The maximum number of master stations is 32 without Repeaters and 125 with Repeaters

Maximum number of slave stations :Vo

PROHBUS@ Standard: 732 bytes per slave module

Data length in DPM: 400 mA/5 VDC

Environmental condition

Operating temperature: 30 to +60°C

Relative air humidity (operating): 5 to 95%, no condensation

Storage temperature: 40 to +85°C

Relative air humidity (storage) : 5 to 95%, with condensation

Contamination level (according to IEC 60664-1) : 2(no condensation)