XVME-675/19  处理器模块   VMEbus背板兼容模块

型号：XVME-675/19

特点:

·跳线可选电压输入范围为10V、2.5V、0-10V、5V、0-5v

·可编程增益为1、2、4或8

·可以在任何VMEbus级别(11-17)中断(STAT)

20 KHz转换速率

XVME-201模拟输入模块是一个VMEbus背板兼容模块，可以在多

达64个不同的单端输入通道或32个差分输入通道上执行12位分辨

率模数转换。它由两部分组成:模拟部分,包含执行模数转换所需

的电路Xycom非智能内核部分，将模拟电路与VMEbus接口。

扩展系统的最低配置包括:

VMEbuS 处理器模块(XVME-654 或XVME-655XVME-978/1 或978/100)

XVIME-976 适配器模块

PC/104 或PMC 扩展模块

适配器模块通过板间连接直接连接到 XVME-654.Nectors 1和 2。成连接所需的内容如下:

两个角支架

两对支架螺钉

将XVME-675/19/ XVME-976 安装到主机 XVME-654 处理器模块

1.遵循防止静电排放的程序，以防止大坝模块电路的老化。

2.断开所有电源.

3.松开XVME-675/19/  XVME-654 处理器模组前面板上的螺丝乌尔。

4.从 VME 背板上卸下 XVME-654，如下所示:轻轻拉动面板，直至其滑出机箱

Model number: XVME-675/19

Features:

· Jumper optional voltage input range is 10V, 2.5V, 0-10V, 5V, 0-5v

· Programmable gain of 1, 2, 4 or 8

· Can be interrupted at any VMEbus level (11-17) (STAT)

20 KHz conversion rate

The XVME-201 analog input module is a VMEbus backplane compatible module that can be used in multiple

Up to 64 different single-ended input channels or 32 differential input channels perform 12-bit resolution

Rate analog-to-digital conversion. It consists of two parts: the analog part, which contains what is needed to perform the analog-to-digital conversion

The non-intelligent core part of Xycom's circuit interfaces the analog circuit with VMEbus.

Minimum configurations for extended systems include:

VMEbuS processor module (XVME-654 or XVME-655XVME-978/1 or 978/100)

XVIME-976 Adapter module

PC/104 or PMC expansion module

The adapter module is directly connected to XVME-654.Nectors 1 and 2 via an interboard connection. The following is required to make a connection:

Two corner bracket

Two sets of bracket screws

Install XVME-675/19/ XVME-976 to the host XVME-654 processor module

1. Follow the procedures to prevent electrostatic discharge to prevent the aging of the dam module circuit.

2. Disconnect all power supplies.

3. Loosen the screws on the front panel of the XVME-675/19/ XVME-654 processor module.

4. Remove XVME-654 from the VME backplane as follows: Gently pull the panel until it slides out of the chassis