SBI-PDP-32  总线连接器

型号：SBI-PDP-32 

S9用于通信的混合连接。它允许连接电容器C3 (10nF 2kV)，以防连接过长

S10用于接地的混合连接。它允许连接电容器4 (10nF 2kV)，以防连接过长。

2.6发光二极管

+5V +5V电源。

RST复位激活。

DEA数据交换阶段激活。

+5VE +5V电源对485驱动侧进行电隔离。

2.7技术规格

储存温度:-20°…+ 70°C(-68…+ 158°F)

工作温度:0°…+ 55°C(32…+ 131°F)

这些温度与卡所在的驱动器的温度相当

连接。

2.8接口

卡应安装在规范卡上，使Profibus-DP

接口卡X0连接器与调节卡X0连接器靠近

彼此总是保持连接器到Profibus-DP线的方向

向下。

对于机械连接，请使用随卡提供的套件。

对于电气连接，请使用40针的扁平电缆，也提供。

为了连接到总线，请使用屏蔽双工电缆。

Model: SBI-PDP-32

The S9 is a hybrid connection for communication. It allows the connection of the capacitor C3 (10nF 2kV) in case the connection is too long

The S10 is used for hybrid grounding connections. It allows the connection of a capacitor 4 (10nF 2kV) in case the connection is too long.

2.6 LED

+5V +5V power supply.

RST reset activated.

DEA data exchange phase is activated.

The +5VE +5V power supply electrically isolates the 485 driver side.

2.7 Technical Specifications

Storage temperature :-20°... + 70°C(-68… + 158°F)

Operating temperature :0°... + 55°C(32… + 131°F)

These temperatures are comparable to the temperature of the drive where the card is located

Connect.

2.8 Ports

The card should be installed on the specification card so that Profibus-DP

The X0 connector of the interface card is close to the X0 connector of the controller card

Always keep the connector in the direction of each other to the Profibus-DP line

Down.

For mechanical connections, use the kit provided with the card.

For electrical connections, use the 40-pin flat cable, also provided.

To connect to the bus, use a shielded duplex cable.