G123-815A001  |   缓冲放大器  简化了PLc在闭合位置回路中的使用

型号：G123-815A001

1范围

这些应用说明是应用G123-815的指南缓冲放大器。他们会告诉你如何安装，连接和调整缓冲放大器。它们不会告诉你如何设计使用它的闭环系统。

2描述

G123-815A001缓冲放大器之间的标准接口PLC模拟输入输出模块，一面，另一端是位置传感器和穆格阀。它简化了PLc在闭合位置回路中的使用。缓冲放大器解决了电路中常见的问题+10V PLC输出与波浪驱动不兼容要求。它还为阀门提供数字噪声滤波位置传感器信号的信号和噪声滤波。有关更详细的说明。

3安装

3.1位置

一种水平的DiN导轨，安装在…的垂直后表面上

一种工业用钢外壳，是预定的方法越来越多。G123-815的脱轨卡应朝向前方下，所以前面板和终端标识是可读，所以内部电子接收冷却气流，放置的重要考虑因素模块是电磁干扰(El)从其他外壳内的设备。例如，VF和交流伺服驱动器可以产生高水平的EMl。一定要检查电磁兼容性在放置G123-815A001之前，请检查其他设备的合规性在附近。

Model: G123-815A001

1 Range

These application notes are a guide to applying G123-815

Buffer amplifier. Will they tell you how to install, connect and

Adjust the buffer amplifier. They don't tell you how to design

Use its closed loop system.

2 Description

The standard interface between the G123-815A001 buffer amplifier is a PLC analog input/output module, on one side and a position sensor and Moog valve on the other. It simplifies the use of PLc in closed position loops. The buffer amplifier solves a common problem in the circuit +10V PLC output is incompatible with wave drive requirements. It also provides the valve with digital noise filtering for the signal and noise filtering of the position sensor signal. For more detailed instructions.

3 Installation

3.1 Location

A horizontal DiN rail, mounted on... Vertical back surface

An industrial steel casing is intended for more and more methods. The G123-815's derailment card should face forward down, so the front panel and terminal identification are readable, so the internal electronics receive cooling airflow, and an important consideration for placing the module is electromagnetic interference (El) from the other enclosures inside the device. For example, VF and AC servo drives can produce high levels of EMl. Be sure to check electromagnetic compatibility before placing the G123-815A001, please check the compliance of other equipment nearby.