HIMA F7133 进口模块

HIMA F7133  进口模块

F7133

制造商已停产

配电模块0

。4通道

H51X的4通道配电，H51g用于扩展机架F-基本机架11，包括小型保险丝5x20，4A-T，H数字输出可用于检测短路和开路输入，例如符合Cat的紧急停止按钮。4按照EN 954-1的说法。为此，输出为脉冲输出，并连接到同一设备的安全相关数字输入，参见第3.1.1章。这种情况下，数字输出承担脉冲输出的功能。致动器上无续流二极管时，可连接感性负载。然而，HIMA强烈建议将保护二极管直接连接到执行器上，故障时的反应如果设备在数字输出上检测到故障信号，受影响的模块输出将使用安全开关设置为安全(断电)状态，如果设备出现故障，所有数字输出都将关闭。在这两种情况下，设备都会激活故障LED。错误代码允许用户在用户程序中配置额外的故障反应

HIMA F7133  进口模块

F7133

The manufacturer has discontinued production

Power distribution module 0

. 4-channel

H51X 4-channel power distribution, H51g for expansion rack F-Basic rack 11, includes small fuses 5x20, 4A-T, H digital outputs can be used to detect short circuits and open circuit inputs, such as a CAT-compliant emergency stop button. 4 According to EN 954-1. For this purpose, the output is a pulse output and is connected to a safety-related digital input of the same device, see Chapter 3.1.1. In this case, the digital output assumes the function of the pulse output. The inductive load can be connected when there is no continuous current diode on the actuator. However, HIMA strongly recommends that the protective diode be connected directly to the actuator, response in case of failure If the device detects a fault signal on the digital output, the affected module output will be set to a safe (power off) state using a safety switch, and all digital outputs will be turned off if the device fails. In both cases, the device activates the faulty LED. Error codes allow the user to configure additional fault responses in the user program

HIMA F7133  进口模块