接器板 DS200SHCBG1A 用于桥接和电机信号连接的端子

GE 分流连接器板DS200SHCBG1A具有一个 2 针连接器和两个用于桥接和电机信号连接的端子。 更换 GE 分流连接器板DS200SHCBG1A时，必须从旧板上断开 3 根电线，然后将它们重新连接到更换板上。最佳做法是为每根电缆创建一个标签，并将标签缠绕在电缆上，或者使用可以压在电缆上的贴纸来连接它。要断开 2 针电缆，请用一只手防止电路板移动，用另一只手抓住电缆连接器并将其从电路板连接器中拉出。

要断开桥接器和电机电缆，请使用扳手或其他手动工具松开并卸下端子上的螺母。将电缆滑出端子并将它们移出工作区。然后，将电缆滑过端子并用一个螺母固定。使用手动工具将其拧紧到足以使其紧贴端子上。过度拧紧螺母可能会导致端子断裂。

DS200SHCBG1A 连接器板是用于连接电子元器件的电路板。

DS200SHCBG1A 连接器板是一种电子元器件，通常用于电路板之间的连接。它具有多种不同的类型和规格，可以根据不同的应用需求进行选择。连接器板在电子设备中起着重要的作用，可以确保电路板之间的稳定连接，并提高系统的可靠性和稳定性。

接器板 DS200SHCBG1A 用于桥接和电机信号连接的端子

The GE SHunt connector board DS200SHCBG1A has a 2-pin connector and two terminals for bridging and motor signal connections. When replacing the GE SHunt connector board DS200SHCBG1A, you must disconnect three wires from the old board and reconnect them to the replacement board. The best practice is to create a label for each cable and wrap the label around the cable, or use a sticker that can be pressed onto the cable to attach it. To disconnect a 2-pin cable, use one hand to prevent the board from moving and use the other hand to grab the cable connector and pull it out of the board connector.

To disconnect the bridge and motor cables, use a wrench or other hand tool to loosen and remove the nuts from the terminals. Slide the cables out of the terminals and move them out of the work area. Then, slide the cable over the terminal and secure it with a nut. Use a hand tool to tighten it enough to fit snug against the terminal. Over-tightening the nut may cause the terminal to break.

The DS200SHCBG1A connector board is a circuit board for connecting electronic components.

The DS200SHCBG1A connector board is an electronic component commonly used to connect circuit boards. It comes in a variety of different types and specifications, which can be selected according to different application requirements. Connector boards play an important role in electronic devices, ensuring stable connections between circuit boards and improving system reliability and stability.