IC693CBL301 GE 总线扩展电缆

Ic693CBL301 GE I/O总线扩展

电缆厂商:GE

型号:IC693CBL301

附加信息:IO总线扩展电缆

IC683CBL301是一种总线扩展电缆，是S0-30系列产品系列的一部分，以前由GE Fanuc ALutomaton提供，目前隶属于Emerson Automaton。该电缆主要用于通过使用IC693CBL301电缆将扩展或远程底板互连到CPU底板的扩展端口来实现IO扩展。该电缆也称为星形电缆，一端有一(1)个25针连接器，另一端有一（1)个公头和一(1)个母头25针连接器。该IC653CBL301的电缆长度为6英尺或2米，具有连续屏蔽。连接此电缆时，25针连接器连接到位于最右侧的CPU扩展端口。电缆的公连接器连接到位于最左侧的扩展或远程底板的25针母连接器。裸露的25针连接器可用于连接到另一个ⅣO总线扩展以进一步互连，或连接到终结器插头以关闭ⅣO总线。单个90-30系列系统最多可使用七(7)个电缆实例。CFU底板和最后一个扩展底板之间的最大总电缆长度不得超过50英尺或15米，或者从CPU到最后一个远程底板的长度不得超过700英尺或213米。未端接的扩展总线或ⅣO总线长度超过建议的测量值将导致通信和O数据交换不稳定.使用CPU 350 -364时，最多支持7根扩展电缆，而使用CPU 331-314时，最多允许使用4根扩展电缆。

安装了IC693CBL301扩展电缆，超过规定的电缆长度，这会导致 90-30 系列 PLC 系统中的运行不稳定，因此，应避免这种情况。用户应始终验证系统内组件的规格。此外，在扩展系统中，用户最多可以使用七根兼容电缆。CPU 底板和最终远程底板之间允许的最大电缆长度为 700 英尺，CPU 底板和最终扩展板之间的电缆长度为 50 英尺。

IC693CBL301 GE 总线扩展电缆

Ic693CBL301 Expands the GE I/O bus

Cable manufacturer :GE

Model :IC693CBL301

Additional information :IO bus expansion cable

The IC683CBL301 is a bus expansion cable that is part of the S0-30 series product family, previously offered by GE Fanuc ALutomaton and currently owned by Emerson Automaton. The cable is primarily used to enable IO expansion by interconnecting the expansion or remote backboard to the expansion port of the CPU backboard using the IC693CBL301 cable. The cable is also known as a star cable with one (1) 25-pin connector at one end and one (1) male and one (1) female 25-pin connector at the other end. The IC653CBL301 has a cable length of 6 feet or 2 meters with continuous shielding. When connecting this cable, the 25-pin connector is connected to the CPU expansion port located on the far right. The male connector of the cable is connected to a 25-pin female connector located on the far left side of the extension or remote baseplate. The bare 25-pin connector can be used to connect to another IV O bus extension for further interconnection, or to a terminator plug to close the IV O bus. A single 90-30 series system can use up to seven (7) cable instances. The maximum total cable length between the CFU baseboard and the last expansion baseboard must not exceed 50 feet or 15 meters, or the length from the CPU to the last remote baseboard must not exceed 700 feet or 213 meters. An unterminated expansion bus or IV O bus length exceeding the recommended measurement value will cause instability in communication and O data exchange.

A maximum of seven expansion cables are supported when CPU 350-364 is used, while a maximum of four expansion cables are allowed when CPU 331-314 is used.

The IC693CBL301 extension cable is installed, exceeding the specified cable length, which can cause unstable operation in the 90-30 series PLC system, therefore, this situation should be avoided. Users should always verify the specifications of the components within the system. In addition, in the extended system, users can use up to seven compatible cables. The maximum allowable cable length between the CPU backboard and the final remote backboard is 700 feet, and the cable length between the CPU backboard and the final expansion board is 50 feet.