DS200DMCBG1AED- GE 电源板组件 包含三个26针连接器

产品信息：

产品型号： DS200DMCBG1AED

品牌：GE

原产地：美国

产品状态:  现货

质保：一年

GE DOS DUP 处理器板DS200DMCBG1AED包含三个 26 针连接器、一个 40 针连接器和 19 个跳线。该板还具有 2 个 LED。GE DOS DUP 处理器板DS200DMCBG1AED还装有两个保险丝，可提供过压保护。如果电路板的电源发生瞬时浪涌，保险丝中的元件熔断，电路板完全停止工作，或在保险丝保护的电路中停止工作。如果保险丝的额定值错误，电路板上的组件会损坏。因此，如果更换保险丝，请仅使用相同额定值的更换件。有关保险丝的信息在出厂时随附的原始电路板的信息中提供。或者，您可能会发现保险丝上印有额定值。

检查保险丝的状况是对电路板进行故障排除的快速初始步骤，因为它只需要目视检查。如果您怀疑电路板的性能未达到预期，您可以打开电路板机柜门并找到电路板上的保险丝。如果一个或两个保险丝熔断，请断开驱动器的所有电源，卸下电路板，然后更换保险丝。重新启动驱动器并确定主板是否恢复正常运行。如果问题仍然存在，下一步是查看电路板上的 2 个 LED。LED 在板上标识为 CR2 和 CR12，亮起时为红色。

DS200DMCBG1AED是通用电气的一种电源板组件。

DS200DMCBG1AED包含三个26针连接器、一个40针连接器和19个跳线，还有两个指示灯，装有两个保险丝，可提供过压保护。如果电路板的电源出现瞬时电涌，保险丝中的元件就会熔断，电路板就会完全停止工作。

DS200DMCBG1AED- GE 电源板组件 包含三个26针连接器

Product Information:

Product model: DS200DMCBG1AED

Brand: GE

Country of Origin: USA

Product status: In stock

Warranty: One year

The GE DOS DUP processor board DS200DMCBG1AED contains three 26-pin connectors, one 40-pin connector, and 19 jumpers. The board also has 2 leds. The GE DOS DUP processor board DS200DMCBG1AED also has two fuses to provide overvoltage protection. If the power supply of the circuit board occurs an instantaneous surge, the components in the fuse are blown, and the circuit board completely stops working, or stops working in the circuit protected by the fuse. If the fuse is rated incorrectly, the components on the circuit board will be damaged. Therefore, if you replace a fuse, only use a replacement with the same rating. Information about fuses is provided in the information on the original circuit board that came with the factory. Alternatively, you may find a rating printed on the fuse.

Checking the condition of the fuse is a quick initial step to troubleshooting the board, as it only requires a visual inspection. If you suspect that the performance of the board is not up to expectations, you can open the circuit board cabinet door and find the fuse on the board. If one or both fuses blow, disconnect all power to the drive, remove the circuit board, and replace the fuse. Restart the drive and determine if the motherboard is up and running again. If the problem persists, the next step is to look at the 2 leds on the board. Leds are identified on the board as CR2 and CR12 and are red when they light up.

The DS200DMCBG1AED is a General Electric power board component.

The DS200DMCBG1AED contains three 26-pin connectors, a 40-pin connector, and 19 jumpers, as well as two indicator lights with two fuses to provide overvoltage protection. If there is an instantaneous surge of power to the board, the components in the fuse will be blown, and the board will stop working completely.