DS200SLCCG1AHH Mark V板元件 安装有 16 位字母数字显示器

DS200SLCCG1AHH  Mark V板元件  安装有 16 位字母数字显示器

DS200SLCCG1AHH是Mark V板元件。它是一个替代的 LAN 通信模块，其表面安装有 16 位字母数字显示器。但请注意，DS200 电平板通常不附带软件 EPROM（U6 和 U7）。在大多数典型的安装中，您将从旧电路板上卸下这些 EPROM，并在新订购的电路板到达后将它们安装在新订购的电路板上。

DS200SLCCG1AHH 模块安装在 Mark V 系统中的 SDCC 模块上。这两个模块通过连接到位于SLCC板上的KPPL连接器的带状连接器连接在一起。安装到位后，SDCC 盖板会卡在 SLCC 模块上，使 16 位字母数字显示屏可见。该显示器的末端有四个针状结构，可保护玻璃覆盖物免受太大的压力。虽然电路板上有几个跳线，但这些引脚不能正常工作。同时，伯格式和跳线的跳线设置可以在相关的用户指南和手册中找到。其他电路板元件包括电阻器、二极管、电阻网络阵列和电容器。

DS200SLCCG1AHH is a Mark V board component. It is an alternative LAN communication module with a 16 digit alphanumeric display installed on its surface. However, please note that DS200 tablets typically do not come with software EPROM (U6 and U7). In most typical installations, you will remove these EPROMs from the old circuit board and install them on the newly ordered circuit board upon arrival.

The DS200SLCCG1AHH module is installed on the SDCC module in the Mark V system. These two modules are connected together through a ribbon connector connected to the KPPL connector located on the SLCC board. After installation, the SDCC cover will be stuck on the SLCC module, making the 16 digit alphanumeric display visible. The display has four needle shaped structures at the end to protect the glass cover from excessive pressure. Although there are several jumpers on the circuit board, these pins cannot function properly. At the same time, the jumper settings for the format and jumper can be found in the relevant user guides and manuals. Other circuit board components include resistors, diodes, resistor network arrays, and capacitors.