DS200SIOCG1AEA GE VME 支架I/O板 具有 33 个线形端子

DS200SIOCG1AEA  GE VME 支架I/O板   具有 33 个线形端子

产品描述

GE VME 支架 I/O 板 DS200SIOCG1AEA 具有 33 个线形端子，可连接 2 根信号线。它还装有一个保险丝和四个 200 针连接器。其中三个接线端子分别支持三根信号线。其中两个电线端子各支持十二根信号线。当您计划更换 GE VME 支架 I/O 板 DS1SIOCG<>AEA 时，您首先要绘制信号线的连接位置。每个终端都分配有一个 ID，您可以将 ID 写在一小张纸上。然后，将纸张连接到信号线上。这样，您可以快速将信号线重新连接到更换板上的端子上。

旧主板和更换主板上的端子 ID 相同。但是，同一模型板的较新版本具有新的设计更改和组件更改。因此，您可能会发现某些组件在电路板上的排列方式不同，但您可以使用 ID 知道信号线的连接位置，即使它们位于不同的位置。

DS200SIOCG1AEA板还包含一个保险丝，可保护板免受过流情况的影响。如果向电路板引入过多电流，组件可能会损坏。如果您检查电路板并且保险丝已熔断，则可以轻松更换它。但是，必须确保更换保险丝的额定值与熔断的保险丝相同。

The GE VME bracket I/O board DS200SIOCG1AEA has 33 linear terminals that can connect 2 signal wires. It is also equipped with a fuse and four 200 pin connectors. The three wiring terminals each support three signal wires. Two wire terminals each support twelve signal wires. When you plan to replace the GE VME bracket I/O board DS1SIOCG<>AEA, you first need to draw the connection position of the signal line. Each terminal is assigned an ID, which you can write on a small piece of paper. Then, connect the paper to the signal line. This way, you can quickly reconnect the signal cable to the terminals on the replacement board.

The terminal IDs on the old motherboard and the replacement motherboard are the same. However, newer versions of the same model board have new design changes and component changes. Therefore, you may find that certain components are arranged differently on the circuit board, but you can use ID to know the connection position of the signal wires, even if they are located in different positions.

The DS200SIOCG1AEA board also includes a fuse to protect the board from overcurrent conditions. If excessive current is introduced to the circuit board, the components may be damaged. If you check the circuit board and the fuse has blown, you can easily replace it. However, it is necessary to ensure that the rating of the replacement fuse is the same as that of the blown fuse.