DS200SIOCG1A 通用电气瞬时过流板 可以接收信号

DS200SIOCG1A  通用电气瞬时过流板  可以接收信号

DS200SIOCG1A 技术指标

制造者 通用电气通用电气

系列 马克五世

部件号 DS200SIOCG1A

产品类型 瞬时过流板

产品描述

GE VersaModular Eurocard （VME） 支架 I/O 板 DS200SIOCG1A 具有五个线端子，可连接 33 根信号线。它还装有一个保险丝和四个 2 针连接器。GE VME 支架 I/O 板 DS200SIOCG1A 上的接线端子块在板上标有 TB-1、TB-2、TB-3、TB-4 和 TB-5。导线携带由电路板传输或在处理过程中由电路板接收的信号。电线用螺钉固定到位，螺钉将电线固定在端子中。每个端子上还印有一个标识符。

更换电路板时，必须首先使用分配给其所连接端子的 ID 标记连接到端子的每根电线。然后，当从电路板上拔下所有电源时，您可以松开将电线固定在端子中的螺钉。检查以确保标签已连接到电线上，并且上面写有正确的端子 ID。将信号线弯曲开，以便卸下旧板并安装更换板。当您准备好重新连接信号线时，将电线的裸露部分插入端子并用一只手将其固定到位。用另一只手用螺丝刀拧紧螺丝。拉上电线以检查它是否牢固并且根本不会自行出来

The GE VersaModular Eurocard (VME) bracket I/O board DS200SIOCG1A has five wire terminals that can connect 33 signal wires. It is also equipped with a fuse and four 2-pin connectors. The wiring terminal blocks on the GE VME bracket I/O board DS200SIOCG1A are labeled with TB-1, TB-2, TB-3, TB-4, and TB-5 on the board. Wires carry signals transmitted by the circuit board or received by the circuit board during processing. The wires are fixed in place with screws, which secure the wires in the terminals. Each terminal is also printed with an identifier.

When replacing a circuit board, each wire connected to the terminal must first be marked with the ID assigned to the terminal it is connected to. Then, when unplugging all power supplies from the circuit board, you can loosen the screws that secure the wires to the terminals. Check to ensure that the label is connected to the wire and has the correct terminal ID written on it. Bend the signal cable open to remove the old board and install the replacement board. When you are ready to reconnect the signal wire, insert the exposed part of the wire into the terminal and fix it in place with one hand. Use the other hand to tighten the screw with a screwdriver. Pull on the wire to check if it is secure and will not come out on its own