DS200PTBAG1A 通用电气马克五世终端板

产品描述

GE 端接板 DS200PTBAG1A 具有 2 个接线端子，每个接线端子中用于 72 根信号线。它还包含 3 个 10 针连接器。10 针连接器的 ID 是 JJR、JJT 和 JJS。它还包含用于 6 根信号线的接线柱。GE 终端板 DS200PTBAG1A 高 3 英寸，宽 11.5 英寸，每个角都有一个孔，用于将板连接到驱动器内的板架上。

由于连接到DS200PTBAG1A电路板的信号线和带状电缆很多，因此最佳做法是绘制出信号线在电路板上的连接位置，并制定计划将电线连接到替换板上的相同连接器。如果未能将信号线连接到相同的端子，则当信号线连接到正确的端子时，驱动器停机时间将增加。这将给现场操作带来不便并降低生产率。

为防止这种情况发生，请在所有信号和带状电缆仍连接的情况下检查驱动器上的旧板。使用终端 ID 在信号线上标记它们所连接的位置。一个接线端子的 ID 为 TB1，另一个为 TB1。要标识特定终端，请使用DS200PTBAG1A终端的数字 ID。例如，TB2 1是TB27接线端子上的端子27。TB1 2 是 TB70 接线端子上的端子 70。您可能会发现创建标记 ID 的标签很有帮助。

The GE termination board DS200PTBAG1A has 2 wiring terminals, each for 72 signal wires. It also includes three 10 pin connectors. The IDs of the 10 pin connector are JJR, JJT, and JJS. It also includes wiring terminals for 6 signal wires. The GE terminal board DS200PTBAG1A is 3 inches tall and 11.5 inches wide, with a hole at each corner for connecting the board to the rack inside the driver.

Due to the large number of signal lines and ribbon cables connected to the DS200PTBAG1A circuit board, the best practice is to draw the connection position of the signal lines on the circuit board and develop a plan to connect the wires to the same connectors on the replacement board. If the signal wire is not connected to the same terminal, the drive shutdown time will increase when the signal wire is connected to the correct terminal. This will bring inconvenience to on-site operations and reduce productivity.

To prevent this from happening, please check the old board on the drive while all signals and ribbon cables are still connected. Use terminal IDs to mark the positions they are connected to on the signal line. One terminal has an ID of TB1 and the other is TB1. To identify a specific terminal, use the digital ID of the DS200PTBAG1A terminal. For example, TB2 1 is terminal 27 on the TB27 wiring terminal. TB1 2 is terminal 70 on the TB70 wiring terminal. You may find it helpful to create tags with tag IDs.