IS200BPIIH1AAA 通过RS-422信号通信门指令和状态信号

IS200BPIIH1AAA，来自GE Speedtronic Mark VI系列，是专为创新系列驱动器使用的桥接电源接口电路板。

IS200BPIIH1AAA由GGXI板通过RS-422信号通信门指令和状态信号。RS-422驱动器和接收器使用点对点信号，如果电缆断开，将报警坏的门信号。IS200BPIIH1AAA使用串行prom ID芯片和上拉电阻。由此产生的上拉信号表明所有电缆沿着信号路径正确连接。

联系电话：18059884797

立即咨询在线留言

产品详情

IS200BPIIH1AAA 通过RS-422信号通信门指令和状态信号

【功能描述】

IS200BPIIH1AAA，来自GE Speedtronic Mark VI系列，是专为创新系列驱动器使用的桥接电源接口电路板。

IS200BPIIH1AAA在它的表面上有四个连接器:两个安装在前面板上，两个在它的后边缘上。后端连接器为128pin背板连接器。引脚信号图可在GEI-100298。两个前连接器设计用于与GGXI板接口。每个连接器，标记为JGATE1和JGATE2，有68个引脚。前面板上有GE标识、单板编号和单板所在位置(6号槽位)，没有安装其他组件。电路板安装不当会损坏组件。请勿插错槽位。该板没有保险丝、用户测试点、LED指示灯或可调节的硬件。

IS200BPIIH1AAA 通过RS-422信号通信门指令和状态信号

The IS200BPIIH1AAA, from the GE Speedtronic Mark VI series, is a Bridge Power Interface circuit board designed for use in Innovation Series drives.

The IS200BPIIH1AAA is used by the GGXI board to communicate gate command and status signals via RS-422 signals. The RS-422 drivers and receivers use point-to-point signaling that will alarm a bad gate signal if the cable is disconnected. The IS200BPIIH1AAA uses a serial prom ID chip and pull-up resistors. The resulting pull-up signal indicates that all cables are properly connected along the signal path.

The IS200BPIIH1AAA has four connectors on its surface: two mounted in the front faceplate and two on its back edge. The rear connectors are 128-pin backplane connectors. Pin signal maps are available in GEI-100298. The two front connectors are designed to interface with the GGXI board. Each connector, labeled JGATE1 and JGATE2, has 68 pins. The front faceplate has no other mounted components but is marked with the GE logo, the board number, and with the proper location of the board (slot 6.) Improper seating of the board can damage the component. Do not insert it in the wrong slot. The board has no fuses, user test points, LED indicators, or adjustable hardware.