DS200SIOBH1ABA vme支架I/O卡

制造商ge通用电气

系列mark V

部件编号ds200siobh1aba

产品类型vme支架I/O卡

联系电话：18059884797

立即咨询在线留言

产品详情

DS200SIOBH1ABA vme支架I/O卡

【功能描述】

DS200SIOBH1ABA技术规范

制造商ge通用电气

系列mark V

部件编号ds200siobh1aba

产品类型vme支架I/O卡

产品描述

GE I/O控制板DS200SIOBH1ABA具有20个跳线和3个开关块，每个块中有6个开关，总共18个开关。它还配备了一个LED和一个40针连接器。原始板上的GE I/O控制板DS200SIOBH1ABA上的跳线带有出厂默认设置的跳线。在安装电路板之前，您可以查看印刷材料中的信息，了解跳线的备选设置以及它们如何改变电路板的操作。有些跳线只有一个支撑位置，因此不能改变。

当您发现必须更换单板时，最好的做法是将新单板上的跳线设置为与旧单板上的跳线位置相匹配。通过这种方式，董事会将采取相同的行动并支持驱动器性能。首先通过移除将其固定在板架上的螺钉来移除旧板，然后用两只手将板从驱动器上移除。小心不要让电路板碰到驱动器中的其他组件。在附近找一个干净干燥的表面，铺平防静电袋。把旧木板放在袋子上。打开装单板的密封保护袋，将单板滑出。用两只手拿着它，把它放在旧板旁边。将开关设置为与旧单板上的开关位置匹配。

DS200SIOBH1ABA vme支架I/O卡

DS200SIOBH1ABA Technical Specifications

Manufacturer GE General Electric

Series Mark V

Part Number DS200SIOBH1ABA

Product Type VME Stand I/O Card

Product Description

The GE I/O Control Board DS200SIOBH1ABA features twenty jumpers and 3 switch blocks with 6 switches in each block for a total of 18 switches. It is also populated with one LED and one 40-pin connector. The jumpers on the GE I/O Control Board DS200SIOBH1ABA on the original board come with the jumpers set for the factory defaults. Before you install the board you can review the information in the printed material to learn about the alternate settings for the jumpers and how they change the operation of the board. Some of the jumpers only have one supported position and so cannot be changed.

When you find that the board must be replaced, the best practice is to set the jumpers in the new board to match the jumper positions on the old board. In this way the board will act the same and support the drive performance. First remove the old board by removing the screws that hold it in the board rack and use two hands to remove the board from the drive. Use care to keep the board from hitting the other components in the drive. Find a clean and dry surface nearby and flatten out a static protective bag. Place the old board on the bag. Open the sealed protective bag that contains the replacement board and slid out the board. Carry it with two hands and place it next to the old board. Set the switches to match the switch positions on the old board.