DS200FSAAG2ABA 现场电源放大器板

制造商ge通用电气

系列mark V

部件编号ds200fsaag2aba

产品类型现场电源放大器板

联系电话：18059884797

立即咨询在线留言

产品详情

DS200FSAAG2ABA 现场电源放大器板

【功能描述】

DS200FSAAG2ABA技术规范

制造商ge通用电气

系列mark V

部件编号ds200fsaag2aba

产品类型现场电源放大器板

产品描述

GE现场电源放大器板DS200FSAAG2ABA具有5个跳线，一个10针连接器和两个熔断器。它还填充了多个测试点。除了10针连接器外，GE现场电源放大器板DS200FSAAG2ABA还配备了四个2针连接器，因此该板可以连接到多个电缆，这些电缆在更换期间必须断开并重新连接。为了避免可能导致驱动器停机时间增加的代价高昂的错误，并使更换变得快速和容易，请在胶带的长度上写上连接电缆的连接器的标识符。然后，将胶带粘在电缆上。只有这样你才能从电路板上断开电缆。当您准备重新连接线缆时，请根据标识找到连接器并重新连接线缆。

断开线缆时，请遵循一定的操作原则，以免造成损坏。拆卸时只能抓住电缆的接头端。如果你从电缆部分拔出，它会对电缆施加压力，并可能因拔出电线而损坏电缆。带状电缆尤其如此，因为多根电线非常细，从带状电缆到连接器的连接没有得到很好的支持。当您重新连接时，请确保电缆完全固定在连接器中，以便所有信号都能够通过电路板。如果连接器有固定夹来固定电路板，请确保它们啮合。

DS200FSAAG2ABA 现场电源放大器板

DS200FSAAG2ABA technical specification

Manufacturer ge General Electric

Series mark V

Part number ds200fsaag2aba

Product Type Field power amplifier board

Product description

The GE field power amplifier board DS200FSAAG2ABA features 5 jumpers, a 10-pin connector, and two fuses. It also populates multiple test points. In addition to the 10-pin connector, the GE Field power amplifier board DS200FSAAG2ABA is equipped with four 2-pin connectors, so the board can be connected to multiple cables that must be disconnected and reconnected during replacement. To avoid costly errors that can lead to increased drive downtime, and to make replacement quick and easy, write the identifier of the connector that connects the cable on the length of the tape. Then, attach the tape to the cable. Only then can you disconnect the cable from the circuit board. When you are ready to reconnect the cable, locate the connector according to the identifier and reconnect the cable.

When disconnecting cables, observe certain operation rules to avoid damage. Hold only the connector end of the cable when removing it. If you pull out of the cable part, it puts pressure on the cable and may damage the cable by pulling out the wire. This is especially true for ribbon cables because the multiple wires are very thin and the connection from the ribbon cable to the connector is not well supported. When you reconnect, make sure the cable is fully secured in the connector so that all signals can pass through the board. If the connector has retaining clips to hold the board in place, make sure they are engaged.