IS420UCSCH1A 四核控制器

IS420UCSCH1A是Mark VIe系列中的第一款四核控制器。该控制器由通用电气公司生产，具有QNX中微子操作系统。当使用QNX Neutrino操作系统时，该控制器具有运行高可靠性和高速操作系统的能力。控制器不仅使用QNX操作系统，还使用EFA(嵌入式现场代理)技术，通过稳定的连接应用Predix基于云的应用程序来提供实时数据。

虽然大多数与Mark VIe系列一起使用的控制器都具有与设备一起使用的I/O功能，但IS420UCSCH1A控制器不具备承载任何应用程序I/O的能力。这个控制器可以在冗余集中使用，当在冗余集中时，这个控制器将把所有附加的I/O网络连接到冗余集中的每个控制器，为控制器提供输入数据。

联系电话：18059884797

立即咨询在线留言

产品详情

IS420UCSCH1A 四核控制器

【功能描述】

安装IS420UCSCH1A控制器时，需要几个要求，其中一些是，直接将UCSC设备安装到安装底座上，在UCSC上方和下方留下至少大约四英寸的气隙，并确保工作温度信封距离UCSC控制器上的任何一点大约一英寸。

与IS420UCSCH1A控制器发生的通信之一是与UDH网络;要与UDH网络通信，需要用ToolboxST应用程序配置一个4gb的闪存驱动器。确定配置所需的所有信息都可以在GEH-6855手册中找到。关于UCSC控制器的信息可以在手册的第二章中找到。

IS420UCSCH1A 四核控制器

The IS420UCSCH1A is the first of the quad-core controllers in the Mark VIe Series. This controller was produced by General Electric to have a QNX Neutrino operating system. When using the QNX Neutrino operating system this controller has the ability to run high-reliability and high-speed operating systems. Not only does the controller use a QNX Operating System, but it uses EFA (Embedded Field Agent) technology to apply Predix cloud-based applications over a stable connection to deliver real-time data.

While most of the controllers used with the Mark VIe Series have the I/O feature used with the device the IS420UCSCH1A controller does not have the capability to host any application I/Os. This controller can be used in a redundant set and when in a redundant set this controller will have all of the attached I/O networks to every controller within the redundant set which provides the controllers with input data.

When mounting the IS420UCSCH1A controller there are several requirements needed, some of which are, directly mounting the UCSC device to the mounting base, leaving a minimum of approximately four inches of air gap above and below the UCSC, and ensuring that the operating temperature envelope is approximately an inch from any point on the UCSC controller.

One of the communications that occur with the IS420UCSCH1A controller is with a UDH network; to communicate with the UDH network a four-gigabyte flash drive will need to be configured with the ToolboxST application. All information needed to determine the configuration can be found in the GEH-6855 manuals. Information on the UCSC controllers is found in chapter two of the manual.