IS200TVBAH2ACC GE 信号接口板

IS200TVBAH2ACC GE  信号接口板

是否有与IS200TVBAH2AAA型号一起工作的板或包?

是的，TVBA模型充当PVIB或YVIB I/O包的信号接口板。IS200TVBAH2AAA模型还可以直接连接速度(地震)测速仪、proximitor和加速度计型探头。该模型还将为模型上的每个输入信号提供电磁接口保护和信号抑制。信号也将被连接到上拉偏置，以允许开路检测。

在TVBA模型上接收到输入信号后发送到哪里?

在TVBA模型上接收到输入信号后，它们将通过37针连接器发送到相关的I/O包。TVBA将根据模型所使用的系统应用程序发出不同的信号。当TVBA模型在三模冗余系统中使用时，所有的信号将被扇形输出到三个I/O包。IS200TVBAH2AAA型号还包含缓冲输出，通过超出正常三十七针连接的附加连接器连接。

这种模式的缺点之一是不知道不同的TVBA群体之间是否存在任何功能差异;因此，用户可能会导致操作问题，由于设备供电过高或过低。用户应参考所有可用的说明手册，以确保它们不会因引起欠压或过压而抑制模型的功能。

IS200TVBAH2ACC GE  信号接口板

Are there boards or packages that work with IS200TVBAH2AAA models?

Yes, the TVBA model acts as a signal interface board for PVIB or YVIB I/O packets. The IS200TVBAH2AAA model can also be directly connected to velocity (seismic) accelerometer, proximitor and accelerometer type probes. The model will also provide electromagnetic interface protection and signal suppression for each input signal on the model. The signal will also be connected to a pull-up bias to allow open circuit detection.

Where is the input signal sent after receiving it on the TVBA model?

After the input signals are received on the TVBA model, they are sent to the relevant I/O packet via the 37-pin connector. TVBA will emit different signals depending on the system application used by the model. When the TVBA model is used in a three-mode redundant system, all the signals are fanned out into three I/O packets. The IS200TVBAH2AAA model also contains a buffered output, connected via additional connectors beyond the normal thirty-seven pin connection.

One of the disadvantages of this model is that it is not known whether there are any functional differences between different TVBA groups; As a result, users may cause operational problems due to the device powering too high or too low. Users should refer to all available instruction manuals to ensure that they do not inhibit the function of the model by causing undervoltage or overvoltage.

IS200TVBAH2ACC GE  信号接口板