IS200STCIH6AED GE 涡轮控制系统的DIN导轨

IS200STCIH6AED GE 涡轮控制系统的DIN导轨

IS200STCIH6A是通用电气Mark VI系列涡轮控制系统的DIN导轨接触端子板。

IS200STCIH6A是一个印刷电路板(PCB)，有许多不同的组件。在板的左右两侧有两个大的镍大小的工厂钻孔。在板的左下角和右下角也有两个工厂钻孔加固的端子孔。旁边的底孔是两个终端带数字标记。上面的集合被标记为1-51，只有奇数，而下面的集合被标记为2-52，所有的偶数。在板的顶部中心边缘有一个RS-232 37针母端口。此板的零件编号标签在板的右下角，在角落和大工厂钻孔之间。有一个白色的3针跳线就在上面的顶部端子带在左边的板。这个PCB还包含2个晶体管，91个电阻，27个二极管和24个电容器。

IS200STCIH6A是一个PCB，应该小心处理。应执行防静电程序，以防止由于静电的积聚和释放而对电路板造成任何类型的损坏。在安装单板之前，请将单板放入防静电包装袋或防静电盒中。安装IS200STCIH6A时，必须佩戴防静电腕带。为了帮助安装，建议记下旧板上的布线和电缆位置，这是替换的。

IS200STCIH6AED GE 涡轮控制系统的DIN导轨

The IS200STCIH6A is a DIN Rail Contact Terminal Board for a GE Mark VI series turbine control system.

The IS200STCIH6A is a printed circuit board (PCB) that has many different components. There are two large nickel-sized factory drilled holes on the right and left sides of the board. There are also two factory drilled reinforced terminal holes on the bottom left and right corners of the board. Next to the bottom holes are two terminal strips that are numerically labeled. The top set is labeled 1-51 with only the odd numbers while the bottom set is labeled 2-52 with all of the even numbers. There is an RS-232 37-pin female port on the top center edge of the board. The part number label for this board is on the bottom right side of the board in between the corner and large factory drilled holes. There is a white 3-pin jumper just above the top terminal strip on the left side of the board. This PCB also contains 2 transistors, 91 resistors, 27 diodes, and 24 capacitors.

The IS200STCIH6A is a PCB and should be handled carefully. Antistatic procedures should be implemented to prevent any type of damage to the board due to a build-up and release of static electricity. The board should be kept in an antistatic bag or box until it can be installed. When installing the IS200STCIH6A, an antistatic wristband should be worn. To help with installation, it is advisable to make a note of the wiring and cable positions on the old board this one is replacing.

IS200STCIH6AED GE 涡轮控制系统的DIN导轨