8507-BI-DP  8507-BI-DP-01 |总线接口模块(BlM)| IS210BPPCH1AD

型号：8507-BI-DP  8507-BI-DP-01

类别：总线接口模块(BlM)

质保：365天

发货方式：：顺丰/联邦

汇款：电汇/西联

8507-B1-DP总线接口模块(BlM)提供PAC8000之间的通信链路

l/0系列模块和PROFlBUS-DP主机。高速采集来自模块和局域网的数据

高达12 Mbaud的操作速度使主机能够快速响应工艺条件的变化。

BlM从l/0模块收集数据，并根据请求将其提供给主机。它是……的奴隶

PROFlBUS主机。以及循环数据交换，这是读输入和写所必需的

输出数据，BlM支持PROFlBUS扩展诊断状态信息。

BlM必须与8701-CA-Bl冗余BlM载波一起使用，如第4页所述。

冗余blm可用于关键应用程序。冗余对中的每个BlM并行运行。

持续检查状态，使备份BlM能够监视主BlM的运行状况。

8507-B1-DP总线接口模块.

特性

支持多达24个1/0模块

冗余的操作

模块和通道状态的扩展诊断

PROFlBUS网络速度可达12mbaud

用于配置的非易失性存储器

可通过PROFlBUS主机配置

HART直通支持监控/配置HART设备

配置/重置ip地址

参数化

8507-Bl-DP支持从PROFlBUS主机进行参数化。配置创建在

PROFlBUS配置器使用GSD文件中提供的详细信息。这种方法速度快，并且可以实现一个

要基于表示物理模块的“逻辑”模块构建的配置。模块

每次向配置中添加一个。

在通信开始时，配置从PROFlBUS主机传递到BlM。低频的

系统停止后重新启动，或者节点经历冷启动周期，配置文件丢失。

转交给BlM。

8507-BI-DP 8507-bi-DP-01 | Bus interface module (BlM)| IS210BPPCH1AD

Model: 8507-BI-DP 8507-BI-DP-01

Category: Bus Interface Module (BlM)

Warranty: 365 days

Delivery method: SF Express/Federal

Remittance: Wire transfer/Western Union

The 8507-B1-DP Bus Interface Module (BlM) provides the communication link between PAC8000

l/0 series module and PROFlBUS-DP host. High-speed data acquisition from modules and local area networks

Operating speeds of up to 12 Mbaud enable the host to respond quickly to changes in process conditions.

The BlM collects data from the l/0 module and provides it to the host on request. It is 's slave

PROFlBUS host. And cyclic data exchange, which is necessary for reading input and writing

Output data, BlM supports PROFlBUS extended diagnostic status information.

BlM must be used with the 8701-CA-Bl redundant BlM carrier, as described on page 4.

Redundant blm can be used for critical applications. Each BlM in a redundant pair runs in parallel.

Continuous status checks enable the backup BlM to monitor the health of the primary BlM.

8507-B1-DP bus interface module.

peculiarity

Supports up to 24 1/0 modules

Redundant operations

Extended diagnostics of module and channel state

PROFlBUS network speeds up to 12mbaud

Non-volatile memory for configuration

This can be configured using the PROFlBUS host

HART Pass-through Supports monitoring and configuration of HART devices

Configure or reset the ip address

parameterization

The 8507-Bl-DP supports parameterization from the PROFlBUS host. Configuration created in

The PROFlBUS configurator uses the details provided in the GSD file. This method is fast and can implement one

A configuration to be built based on a "logical" module that represents a physical module. module

Add one at a time to the configuration.

At the beginning of the communication, the configuration is passed from the PROFlBUS host to the BlM. low-frequency

The system restarts after being stopped, or the node experiences a cold start period, and the configuration file is lost.

To the BlM. .