IS200JPDMG1ACC  | PCB组件 |  高密度配电卡

型号：IS200JPDMG1ACC

电源电压:24VDC

功耗:<20 瓦特

通信协议:Modbus、Profibus、

EthernetlP

数据传输速率:高达 10 Mbps

额定温度范围:-40°C至 +70°C

防护等级:IP67

产品描述

该IS200JPDMG1ACC 是通用电气作为Mark VI系统的一部分创建的PCB组件。Mark VI 由 GE 发布，作为其用于燃气和蒸汽轮机管理的 Speedtronic 系列的一部分，该系列始于 1960 年代 Mark I 的发布。Mark VI 通常由 125Vdc 电池系统供电。但是，它可以从 120/240vac 电源供电，使用带有隔离变压器的电源转换器将电源整流到 125Vdc。对于燃气轮机，短路保护为 20A 或更低的点火变压器需要单独的电源。

IS200JPDMG1ACC是高密度配电卡。 该板为每个 I/O 包提供单独的受保护控制电源。可以使用 J1 和 J1X 连接器将多个IS200JPDHG1A板菊花链连接在一起;但是，完成此操作后，输入电流不能超过第一个 JPDH J1 插头的额定值。该IS200JPDHG1A可用于一些危险场所，包括 1 类 2 区、1 类 2 区和 ATEX。用户必须遵循 UL/ATEX HazLoc 的接线和维护要求。

Model: IS200JPDMG1ACC

Power supply voltage :24VDC

Power consumption :<20 watts

Communication protocol :Modbus, Profibus,

EthernetlP

Data transfer rate: up to 10 Mbps

Rated temperature range :-40°C to +70°C

Protection level :IP67

Product description

The IS200JPDMG1ACC is a PCB component created by GE as part of the Mark VI system. The Mark VI was released by GE as part of its Speedtronic line for gas and steam turbine management, which began with the release of the Mark I in the 1960s. The Mark VI is typically powered by a 125Vdc battery system. However, it can be powered from a 120/240vac supply, using a power converter with isolation transformer to rectifying the power supply to 125Vdc. For gas turbines, ignition transformers with short circuit protection of 20A or less require a separate power supply.

IS200JPDMG1ACC is a high density distribution card. The board provides a separate protected control power supply for each I/O packet. Multiple IS200JPDHG1A boards can be Daisy chained together using J1 and J1X connectors; However, after this is done, the input current cannot exceed the rating of the first JPDH J1 plug. The IS200JPDHG1A can be used in a number of hazardous locations, including Class 1 Zone 2, Class 1 Zone 2 and ATEX. The user must follow the wiring and maintenance requirements of UL/ATEX HazLoc.