DS200CLACG1A  |  驱动器   |  具有可用于测试板上电路的测试点

产品参数:

型号：DS200CLACG1A

输入电压:24vdc

额定电流:500ma

-工作温度:-40°℃~ +70℃

-通信接口:RS485

“内存容量”:32kb

GE PC Board DS200CLACG1AAA具有一个 2 针连接器、四个测试点和四个用于安装的螺丝孔。GE PC 板DS200CLACG1AAA还具有可用于测试板上电路的测试点。板的尺寸为高 2.5 英寸，长 5 英寸。螺钉设计用于与驱动器中电路板机架上的匹配孔对齐。卸下有缺陷的驱动器时，请注意电路板在机架中的位置，并保留从旧电路板上卸下的四个螺钉和垫圈。用两只手取下旧板。用一只手握住螺丝刀并转动它。另一只手握住螺钉和垫圈，以防止它们掉入驱动器中。如果一个或多个螺钉和垫圈掉入驱动器中，请停止该过程并找到并取回物品。硬盘中遗留的任何物品都存在安全隐患，可能会引起电击或损坏硬盘内的运动部件。更换时，您必须使用腕带来防止静电积聚。表带的一端缠绕在手腕上，另一端设计有夹子，您可以将其固定在裸露的金属表面上。这可能是工作台腿或支撑结构上的裸露金属表面。

Product parameters:

Model: DS200CLACG1A

Input voltage :24vdc

Rated current :500ma

- Operating temperature :-40° C ~ +70 ° C

- Communication port :RS485

Memory Capacity :32kb

The GE PC Board DS200CLACG1AAA has a 2-pin connector, four test points, and four screw holes for mounting. The GE PC board DS200CLACG1AAA also has test points that can be used to test circuits on the board. The dimensions of the board are 2.5 inches high and 5 inches long. The screws are designed to align with matching holes in the circuit board rack in the driver. When removing a defective driver, note the position of the circuit board in the rack and keep the four screws and washers removed from the old circuit board. Remove the old board with two hands. Hold the screwdriver with one hand and turn it. Hold the screws and washers with the other hand to prevent them from falling into the drive. If one or more screws and washers fall into the drive, stop the process and find and retrieve the item. Any items left behind in the hard drive are a security hazard and may cause electric shocks or damage moving parts inside the hard drive. When replacing it, you must use a wrist strap to prevent static buildup. One end of the band wraps around your wrist, and the other end is designed with clips that you can attach to a bare metal surface. This could be an exposed metal surface on the table legs or support structures. Some wristbands come with a plug that you can connect to a matching connector on the workbench. For this Mark V Series product, it is critical to follow the installation instructions determined by GE, as this is essential to avoid any potentially lethal surface voltages on this DS200 normally assembled product.