DS200TCQCG1AJD  |  RST 溢出板  具有 3 个 34 针连接器

产品描述

GE RST 溢出板DS200TCQCG1AHD装有 24 个跳线和 3 个 40 针连接器。它还具有 3 个 34 针连接器和 1 个 16 针连接器。分配给 16 针连接器的 ID 为 JC。分配给 40 针连接器的 ID 为 JFF、JE 和 6PL。GE RST 溢流板上的 24 个跳线DS200TCQCG1AHD板的配置中发挥重要作用。跳线有两个位置，安装人员可以在这两个位置上设置跳线。根据选择，董事会将以不同的方式处理信息。跳线定义为 3 针跳线。也就是说，跳线可以覆盖引脚 1 和 2 或引脚 2 和 3。跳线在其覆盖的两个引脚之间进行电接触。有些跳线不是由安装人员设置的，而是在产品测试期间由工厂使用的。在这种情况下，一个位置供制造商使用，另一个位置在正常操作期间使用。

这款DS200TCQCG1AJD印刷电路板在其组装中使用了几种不同的相关 Mark V 系列连接器类型，包括：

JBR TCQA 板输入信号连接器

JFR TCQA 板 LVDT/R 位置信号连接器

JBS/T 连接器

JFS/T 连接器

TEST 连接器

Product description

The GE RST overflow board DS200TCQCG1AHD is equipped with 24 jumpers and 3 40-pin connectors. It also features three 34-pin connectors and one 16-pin connector. The ID assigned to the 16-pin connector is JC. The ids assigned to 40-pin connectors are JFF, JE, and 6PL. The 24 jumpers on the GE RST overflow board play an important role in the configuration of the DS200TCQCG1AHD board. The jumper has two positions where the installer can set the jumper. Depending on the choice, the Board will handle the information in different ways. The jumper is defined as a 3-pin jumper. That is, the jumper can cover pins 1 and 2 or pins 2 and 3. The jumper makes electrical contact between the two pins it covers. Some jumpers are not set by the installer, but are used by the factory during product testing. In this case, one location is used by the manufacturer and the other is used during normal operation.

This DS200TCQCG1AJD printed circuit board uses several different related Mark V Series connector types in its assembly, including:

JBR TCQA board input signal connector

JFR TCQA board LVDT/R position signal connector

JBS/T connector

JFS/T connector

TEST connector