IS220PPDAH1B   | 配电系统反馈模型 用于调节电路板反馈信号

型号：IS220PPDAH1B

输出电压 :28 伏直流电

执行的自我诊断测试次数: 五

安装位置 :在 JPDS、JPDC 或 JPDM 板上

制造者 :GE能源

手动 GEH-6721 Mark VIe Control Vol. II 系统硬件指南

功能缩略语/缩写; PPDA系列

诊断信号: 两个 115/230 VAC 模拟反馈、本地接地信号、六个保险丝交流电等

使用JPDE板进行检测 接地故障检测

产品描述

IS220PPDAH1B板是通用电气为Mark VIe系统生产的配电系统反馈模型。 该模型用于调节电路板反馈信号，还可以为连接的控制器提供以太网接口。该电池组的反馈是即插即用的，它将使用插入的电子 ID 来确定所连接的配电型号的功率。来自配电模型的信息将继续用于占用 IONet 输出，以提供来自连接的正确反馈。

虽然 IS220PPDAH1B 包与 JPDC、JPDS、JPDM 和 JPDG 电源板兼容，但它仅与来自 JPDB、JPDF 和 JPDE 板的反馈信号兼容。通常，此PPDA包安装在以下电路板之一上;JPDM、JPDC 或 JPDS。通过引脚一对一连接器的接线，可以使用 50 针带状电缆跳线将该包连接到更多电路板。

Model: IS220PPDAH1B

Output voltage :28 volts DC

Number of self-diagnostic tests performed: 5

Installation location: On JPDS, JPDC or JPDM board

Manufacturer :GE Energy

Manual GEH-6721 Mark VIe Control Vol. II System Hardware Guide

Functional abbreviations/abbreviations; PPDA Series

Diagnostic signals: two 115/230 VAC analog feedbacks, local ground signal, six fuses AC, etc

Ground fault detection using JPDE board

Product description

The IS220PPDAH1B board is a distribution system feedback model produced by General Electric for the Mark VIe system. The model is used to regulate the feedback signals of the circuit board, and can also provide an Ethernet interface for the connected controller. Feedback from the battery pack is plug-and-play, and it will use the plugged electronic ID to determine the power of the connected distribution model. The information from the distribution model will continue to be used to occupy the IONet output to provide the correct feedback from the connection.

While the IS220PPDAH1B package is compatible with JPDC, JPDS, JPDM, and JPDG power boards, it is only compatible with feedback signals from JPDB, JPDF, and JPDE boards. Typically, this PPDA package is mounted on one of the following boards; JPDM, JPDC, or JPDS. The pack can be connected to more boards using 50-pin ribbon cable jumpers through wiring of the pin-to-pin connector.