IC697LBR701  |  90-30 PLC控制器     电源模块

型号：IC697LBR701

系列 ：90-30 PLC控制器

滞留时间： 最少 21 毫秒

过流限制 +5 VDC 输出：26 安培，最大值 +12 VDC 输出：4 安培，最大值 -12 VDC 输出：2 安培，最大值

过压限制 +5 VDC 输出：5.7 至 6.7 伏

该IC697PWR711是 Ge Fanuc 90-30 系列可编程逻辑控制器 （PLC） 系列的电源模块。该模块具有可选的输入电压兼容性，例如 120 VAC 和 240 VAC，由外部跳线设置决定。对于两个标称 vali 输入电压，适用的电压范围为 90 至 132 VAC 或 180 至 264 VAC，频率为 47 至 63 Hz。

该IC697PWR711具有 +5VDC、12VDC 和 -12VDC 的输出电压电源以及通往背板的逻辑电平排序信号。此电源安装在 90-30 机架的最左侧位置，通过 48 针背板连接器连接。此电源能够为第二个机架供电，前提是附加机架的总负载不超过IC697PWR711的总 100 瓦容量。具体来说，第二个机架必须小于 5.2 安培。此外，为第二个机架供电需要使用 3 英尺的连接电缆。第二个机架必须在此电缆的可触及范围内，因为它的设计运行距离不超过 3 英尺。

Model: IC697LBR701

Series: 90-30 PLC controller

Retention time: Minimum 21 ms

Overcurrent limit +5 VDC output: 26 amps, maximum +12 VDC output: 4 amps, maximum -12 VDC output: 2 amps, maximum

Overvoltage limit +5 VDC output: 5.7 to 6.7 volts

The IC697PWR711 is a power module for the Ge Fanuc 90-30 series Programmable Logic Controller (PLC) series. The module has optional input voltage compatibility, such as 120 VAC and 240 VAC, as determined by external jumper Settings. For two nominal vali input voltages, the applicable voltage range is 90 to 132 VAC or 180 to 264 VAC, and the frequency is 47 to 63 Hz.

The IC697PWR711 has a +5VDC, 12VDC and -12VDC output voltage supply and a logic level ordering signal to the backplane. This power supply is mounted on the far left side of the 90-30 rack and is connected via a 48-pin backplane connector. This power supply is capable of powering a second rack, provided that the total load of the additional rack does not exceed the total 100-watt capacity of the IC697PWR711. Specifically, the second rack must be less than 5.2 amps. In addition, 3 feet of connecting cable is required to power the second rack. The second rack must be within reach of this cable, as it is designed to operate no more than 3 feet away.