XVME-6200  双核处理器  增强型IDE控制器

XVME-6200 VMEbus英特尔*酷睿2“Duo和Core Duo PC兼容的VMEbus处理器模块结合了VMEbus的高性能和坚固的封装以及IBM PC/AT标准的广泛应用软件基础。它集成了最新的处理器和芯片组技术。不同版本的XVME-6200之间的唯一区别是所使用的CPU。L7400是我们所有处理器中功耗最低的，同时保持非常高的处理能力。T7400提供了最高的性能。

XVME-6200提供以下功能:

·英特尔“酷睿2”双核处理器。所有型号的处理器都可以配置1GB到8GB的SDRAM(显示为主板上的总内存)

英特尔酷睿2双核上的二级高速缓存为4MB(T7400和L7400)。

视频控制器与4MB的VRAM。(硅运动722)

增强型IDE控制器，可在P2上驱动两个EIDE设备(兼容XVME-977硬盘/软驱单元和XVME-979硬盘/DVDCDROM驱动单元)

P2区有两个SATA-150频道使用XVME-990提供连接外部SATA驱动器所需的连接器

软盘控制器，可在P2上驱动一个软盘驱动器(兼容XVME-977硬盘/软盘驱动器或XVME-979 CD-ROM/DVD驱动器和带外置驱动器的硬盘驱动器)

双10/100/1000基地T以太网控制器与前面板RJ-45连接器与隔离地或可选出P0支持后方以太网或维塔31.1。

使用我们的XVME-912可选载体键入lCompact Flash站点。这将安装在PMC站点中，不允许使用PMC模块。

使用XVME-913 1.8的车载硬盘“硬盘驱动器。这将安装在PMC站点中，不允许使用PMC模块。

VME64XVMEbus接口，可编程硬件字节交换

在投诉背板中支持Vita 31.1交换结构

三个串口:·前面板上的一个RS-232串行端口(Com1)带有电隔离(Com1端口可配置为RS-232/422/485)P2上的一个RS-232串行端口(Com2)(使用我们的XVME-990访问)

四个通用串行总线(USB2.0)端口1和2在前面和3和4出P2。(使用我们的XVME-990访问)XVME-990上26针头上的EPP/ECP可配置并行端口(P2)

前面板上的组合PS/2兼容键盘/鼠标端口。后键盘/鼠标使用USB。

PCI80针扩展连接器(不兼容XVME-976-01至XMVE-976-205载体)必须使用XVME-9076。

The XVME-6200 VMEbus Intel * Core 2 "Duo and Core Duo PC-compatible VMEbus processor modules combine the high performance and rugged package of VMEbus with the broad application software foundation of the IBM PC/AT standard. It integrates the latest processor and chipset technologies. The only difference between the different versions of XVME-6200 is the CPU used. The L7400 is the lowest power consumption of all our processors, while maintaining very high processing power. The T7400 offers the highest performance.

XVME-6200 provides the following functions:

· Intel "Core 2" dual-core processor. All processor models can be configured with 1GB to 8GB of SDRAM(shown as the total memory on the motherboard)

The Level 2 cache on the Intel Core 2 Duo is 4MB(T7400 and L7400).

Video controller with 4MB of VRAM. (Silicon Motion 722)

Enhanced IDE controller that drives two EIDE devices on P2 (compatible with XVME-977 hard disk/floppy drive unit and XVME-979 hard disk /DVDCDROM drive unit)

Zone P2 has two SATA-150 channels that use XVME-990 to provide the connectors needed to connect external SATA drives

Floppy disk controller that drives a floppy disk drive on P2 (compatible with XVME-977 hard/floppy disk drive or XVME-979 CD-ROM/DVD drive and hard drive with external drive)

Dual 10/100/1000 base T Ethernet controllers with front panel RJ-45 connectors with isolation ground or optionally P0 to support rear Ethernet or Vita 31.1.

Type the lCompact Flash site using our XVME-912 optional carrier. This will be installed in the PMC site and will not allow the use of PMC modules.

Use XVME-913 1.8 car hard disk "hard drive. This will be installed in the PMC site and will not allow the use of PMC modules.

VME64XVMEbus interface, programmable hardware byte exchange

The Vita 31.1 switching structure is supported in the complaint backplane

Three serial ports :· One RS-232 serial port (Com1) on the front panel with electrical isolation (Com1 port can be configured as RS-232/422/485) One RS-232 serial port (Com2) on P2 (accessed using our XVME-990)

Four Universal Serial Bus (USB2.0) ports 1 and 2 on the front and 3 and 4 out of P2. (Accessed using our XVME-990) EPP/ECP configurable parallel port (P2) on 26 pins on XVME-990

The combination PS/2 on the front panel is compatible with keyboard/mouse ports. The rear keyboard/mouse uses USB.

Pci80-pin expansion connectors (not compatible with XVME-976-01 to XMVE-976-205 carriers) must use XVME-9076.