IC694CHS392是GE发那科公司生产的Rx3i PacSystem串行扩展标准I/O背板。这个10槽系统可以容纳10个输入和输出槽。说明最左边的槽位必须安装IC694PWR331、IC694PWR330或IC694PWR321串行电源。安装模块前,用户需要设置IC694CHS392拨码选择开关。但是请注意,背板上不允许热安装和热拆卸模块。
在右端,串行背板有一个总线连接器,用于附加可选或额外的扩展电缆。注意,扩展电缆的长度不应超过15米或50英尺。背板长5.12英寸,宽17.44英寸,高5.59英寸,额定电流150mA,电压5VDC。
技术规格
模块类型:标准I/O
背板支持:高速串行仅
槽位数量:10个
距离:高达50英尺
尺寸:5.12 x 17.44 x 5.59英寸。(高×宽×深)
内部使用电源:150ma @ 5vdc
The IC694CHS392 is an Rx3i PacSystem Serial Expansion Standard I/O Backplane manufactured by GE Fanuc. This 10-slot system can accommodate 10 input and output slots. The slot occupied at the leftmost part is must be occupied by one of the following serial power supplies: IC694PWR331, IC694PWR330, or IC694PWR321. Before a module is installed, a user should ensure to set the IC694CHS392 DIP selection switch. Note, however, that hot installation and removal of modules is not allowed on the backplanes.
At the right end, the serial backplane has a bus connector provision for the attachment of optional or additional expansion cables. Note that expansion cable length should not exceed 15 meters or 50 feet. The backplane measures 5.12 x 17.44 x 5.59 inches in length, width, and height respectively and runs on 5VDC at a rated current of 150mA.
Technical Specifications
Module Type: Standard I/O
Backplane Support: High Speed Serial Only
Number of Slots: 10
Distance: Up to 50 feet
Dimensions: 5.12 x 17.44 x 5.59 in. (H x W x D)
Internal Power Used: 150 mA @ 5 VDC
Copyright © 2022-2024 厦门雄霸电子商务有限公司 版权所有 备案号:闽ICP备14012685号-33