型号:P0916NG
校准要求:P0916NG模块和端接组件无需校准。每个通道均与所有其他通道和大地电隔离。该模块可以承受在任何通道和接地之间或给定通道和任何其他通道之间施加一分钟的 600VAC 电压,而不会损坏。
沟通 :通过冗余 2Mbps 模块现场总线与其关联的 FCM 或 FCP 进行通信
感性负载 :P0916NG模块输出可能需要在感性负载上连接一个保护二极管或金属氧化物压敏电阻 (MOV)。
负载电流-浪涌 30°C 时每通道 20 ms 为 8 A(最大值),70°C 时每通道 20 ms 为 6.4 A(最大值)。
通态压降 :2.25A 时为 0.2V(最大值)
输入电压范围(冗余)24VDC+5%,-10%功耗(最大)
储存条件
温度-40至+85摄氏度(-40到+185华氏度)
相对湿度5至95%(不凝)
高度-300米至+12,000米(-1,000至+40,000英尺)
污染
P0916NG适用于在ISA标准S71.04所定义的G3类(严酷)环境中使用根据ELA标准364-65,I类进行暴露测试。
振动
7.5m/s2M5赫兹到500赫兹
Model: P0916NG
Calibration requirements: P0916NG modules and end components do not require calibration. Each channel is isolated from all other channels and geoelectrics. The module can withstand a 600VAC voltage applied for one minute between any channel and ground or between a given channel and any other channel without damage.
Communication: Communication with its associated FCM or FCP via a redundant 2Mbps module fieldbus
Inductive load: The P0916NG module output may require a protective diode or metal oxide varistor (MOV) to be connected to the inductive load.
Load current - 8 A at 20 ms per channel at 30°C (maximum) and 6.4 A at 20 ms per channel at 70°C (maximum).
On-state voltage drop: 0.2V at 2.25A (Max)
Input voltage range (redundancy)24VDC+5%, -10% power consumption (Max)
Storage condition
Temperature -40 to +85 degrees Celsius (-40 to +185 degrees Fahrenheit)
Relative humidity 5 to 95%(non-condensing)
Height -300 m to +12,000 m (-1,000 to +40,000 ft)
contaminate
P0916NG is suitable for use in G3 (harsh) environments defined by ISA standard S71.04 for exposure testing in accordance with ELA standard 364-65, Class I.
Vibration
7.5m/s2M5 Hz to 500 Hz
Copyright © 2022-2024 厦门雄霸电子商务有限公司 版权所有 备案号:闽ICP备14012685号-33